Instructions for the Graco Newborn Napper Pack 'n Play. Assembling your baby gear can seem like one of the hardest parts of preparing for your baby, especially when the item in question is a play yard with multiple parts and functions. However, you can assemble Author: Rachel Kolar. Pack ‘n Play® Playard Newborn Napper® PDB 8/15 Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Lea todas las instrucciones ANTES de armar y USAR este. Graco ® Pack 'n Play ® with Newborn Napper ® Elite grows with your child from newborn to toddler and is the perfect blend of luxury and convenience. Pack 'n Play® Newborn Napper® Elite Playard Pack 'n Play® Newborn Napper® Elite Playard under 35" tall. Changing table weight limit: Varies by model. Check product instructions for.
Each time you press the button, a new sound will play. Check to ensure you have all the necessary parts for the Pack 'n Play with Newborn Napper. Do not use the play yard when your baby exceeds 35 pounds or 32 inches. You will hear an audible snap as it clicks into place. The plastic end of each tube should touch the metal end of the other tube. Locate the two snaps on the side of the play yard.
A resident of the Baltimore area, Rachel Kolar has been writing since If the rails will not lock, pull the center of the play yard's floor higher, as all four rails cannot snap into place if the floor has locked first. If you press it after the volume reaches its maximum level, the music or sounds will stop. Because the tube is curved, you will need to guide the fabric of the changing table around the tube carefully to keep it from catching. The snap button should face downward into the napper. Insert the other tube into the opposite side of the changing table in the same manner.
Insert the short metal poles into the fabric tubes at the bottom of the bassinet. Plug the cord from the vibrator unit into the electronic module. You will hear an audible snap as it clicks into place. Close the pocket, leaving one end of the cord loose. Snap the corresponding buttons on the diaper stacker into those two snaps. Because the tube is curved, you will need to guide the fabric of the changing table around the tube carefully to keep it from catching. Your baby could become trapped between a smaller mattress and the side of the play yard, bassinet or napper. Clip the canopy into place on the sides of the napper and fasten the hook and loop closures to the bottom of the napper. The snap button should face downward into the napper.